Let’s go through the process of DIY Dresser Renovation using wallpaper:
- Prepare Your Furniture
If any repairs require to be made to the furniture, proceed, as well as make every one of the repair services first thing. When sticking wallpaper on a piece of furniture, you desire the surface area of your furnishings item to be entirely smooth. Plan the ended-up appearance, including what equipment you will be using. If the present equipment holes do not benefit the new hardware, go on as well as wood fill the old equipment holes, as well as pierce the holes for the new hardware.
- Sand Your Furniture
Gently sand down the entire piece utilizing a sand sponge. Be sure to sand with the instructions of the timber grain to ensure that you don’t scrape the wood surface. This light sanding is simply to eliminate any dirt, as well as give the surface area a little porosity as well as holding power for the paint. This is not something you want to press super hard-on as well as sand through the leading veneer surface area, this is a light sanding!
- Tape Your Furnishings for Painting
Tape off every edge as well as drawer runner using painter’s tape to ensure that your painted sides stay clean as well as crisp.
- Paint Your Furnishings
Pour the paint shade of your selection in the paint tray, as well as get your paintbrush and foam roller prepared. Some particular furniture piece has flat surface areas. essentially, I roll nearly the entire item with a foam roller. There were a few minor locations where I cut in around the sides with a paintbrush.
- Preparation Your Wallpaper for Installation
As soon as you are completely done with painting, and the piece is totally dry, usually 4 to 6 hours, it is time to plan your wallpaper application. Keep in mind: You must have already pre-prepared general chevron wallpapers layouts for the item that you are creating.
- Use the Wallpaper to the Furnishings Sides
Apply the wallpaper sideways of the furniture. With this furniture piece, there was an ideal inlay circumstance on the sides, so I roughly measured the size of the wallpaper item that I needed by holding the wallpaper approximately the side of the furnishings piece, as well as sufficed as necessary, leaving concerning an inch or so in excess. As soon as you have your wallpaper piece cut out, remove the support, as well as stick-on wallpaper.
